Installation Advice when using stainless steel slotted railing

  1. MOUNTING PROFILE BASE SHOE – ALUMINUM

Drill diameter 14mm holes in the edge of the floor with an electric drill, the next step is install the aluminum base shoe with the stainless steel cap M8 set screws. The total height of aluminum base shoe is 140mm, the width is 51mm. Inner height and width is 105mm and 28mm. Available finish is dull polished and mirror polished.

  1. SAFETY WEDGE KIT

Install the vinyl setting block into the aluminum base shoe without glue.

  1. MAX. 21.52MM TEMPERED GLASS

Max. 2152mm thickness tempered glass with all exposed edges Flat Polished.

  1. GLASS GASKET

Gasket to the inside face of the Max. 21.52mm thickness tempered glass. The material of gasket is EPDM, black color, soft.

  1. TOPRAIL – STAIINLESS STEEL

Stainless steel groove tube bond to top edge of the tempered glass, which is supplied in 304 and 316L material. Normal size tube is Diameter 42.4mm with slot 24x24mm and Diameter 48.3mm slot 27x30mm. Stainless steel top rail is available in Brushed Finish and Mirror Finish.

Note: A continuous stainless glass railing is required when protecting a fall of over 1000mm and to prevent glass breakage, by protecting the top edge from being struck by hard objects. Joins to be adequately supported by 180 Degree U tube connector extrusion. Corners to be adequately supported by the 90-degree connector.

Leave a Reply

Your email address will not be published. Required fields are marked *